Automatic lathe machining tools and turning tools

April 29, 2023

Do not put the automatic lathe processing tools and turning tools on the bed surface to avoid knocking the guide rails. If you need to put it, cover the bed cover on the bed and put the tool and the knife on the bed cover.
a When sanding the workpiece, cover it with a bed cover or paper on the bed under the workpiece; after sanding, carefully clean the surface of the bed.
b When the cast iron workpiece is in the car, install the guard cover on the stern plate, and at the same time wipe off the lubricating oil on the surface of the bed that the chip can splash.
c When not in use, the lathe must be cleaned and maintained to prevent chips, sand or impurities from entering the sliding surface of the lathe rail, causing the rail to “bite” or aggravate its wear.
d Before using the cooling lubricant, the garbage in the lathe rail and the cooling lubricant pan must be removed; after use, the cooling lubricant on the rail should be wiped dry and mechanically lubricated.

Bizimle iletişime geçin

Author:

Ms. SU LAN RONG

E-posta:

susu@cn-tianhui.com

Phone/WhatsApp:

++86 13396680822

Popüler Ürünler

Şirket haberleri

Boru hassas parçaları

November 11, 2024

Özel Hassas Endüstriyel Makine Metal Aksesuarları

November 07, 2024

You may also like

Related Categories

Bu tedarikçi için e-posta

Konu:

E-posta:

İleti:

Your message must be betwwen 20-8000 characters

Bizimle iletişime geçin

Author:

Ms. SU LAN RONG

E-posta:

susu@cn-tianhui.com

Phone/WhatsApp:

++86 13396680822

Popüler Ürünler

Şirket haberleri

Boru hassas parçaları

November 11, 2024

Özel Hassas Endüstriyel Makine Metal Aksesuarları

November 07, 2024

Blog News

"Rethinking the Global Mobile Speed Countdown: A Call to Action for Operators and Regulators"

November 06, 2024

"Flavorful Experiences: The Lighting Design Journey of Aaya London Restaurant"

November 06, 2024